Lexmark 436 Bedienungsanleitung PDF herunterladen (Seite 187)

840.02 Scanner Auto Disabled

This message indicates the printer identified a problem with the scanner and automatically disabled it.

1 Remove all pages from the ADF.

2 Turn the printer off.

3 Wait 15 seconds, and then turn the printer on.

4 Place the document in the ADF.

5 Press .

Note: If turning the printer off and then on again does not clear the message, then contact your system support

person.

Solving printing problems

Jobs do not print

These are possible solutions. Try one or more of the following:

MAKE SURE THE PRINTER IS READY TO PRINT

Make sure Ready or Power Saver appears on the display before sending a job to print.

CHECK TO SEE IF THE STANDARD EXIT BIN IS FULL

Remove the stack of paper from the standard exit bin.

CHECK TO SEE IF THE PAPER TRAY IS EMPTY

Load paper in the tray.

MAKE SURE THE CORRECT PRINTER SOFTWARE IS INSTALLED

• Verify that you are using the correct printer software.

• If you are using a USB port, make sure you are running a supported operating system and using compatible printer

software.

MAKE SURE THE INTERNAL PRINT SERVER IS INSTALLED PROPERLY AND WORKING

• Make sure the internal print server is properly installed and that the printer is connected to the network. For

more information about installing a network printer, click View User's Guide and Documentation on the Software

and Documentation CD.

• Print a network setup page and check that the status shows Connected. If the status is Not Connected, check the

network cables, and then try printing the network setup page again. Contact your system support person to make

sure the network is functioning correctly.

Copies of the printer software are also available on the Lexmark Web site at www.lexmark.com.

Troubleshooting 187

1 2 ... 182 183 184 185 186 187 188 189 190 191 192 ... 234 235

Keine Kommentare

Lexmark 436 Bedienungsanleitung Seite 187